Home   >   News   >   Seeed’s Grove Base Kit for Raspberry Pi Now Available for $40

Seeed’s Grove Base Kit for Raspberry Pi Now Available for $40

By on May 11, 2019
Pin It

The Seeed Studio Grove Base Kit for Raspberry Pi is a beginners kit for beginners to get started with the Raspberry Pi in a fun and easy way.  It has 10 Grove sensors instead of 12 on Seeed’s GrovePi+ Starter Kit, but it also adds three sensors: Mini PIR motion sensor, moisture sensor, and servo. It lacks the Starter Kit’s sound, rotary angle, and button sensors, as well as the blue and green LEDs.

This Base Hat is based on the STM32 MCU which has a 12-bit 8-channel ADC and has 6-Digital, 4-Analog, 3-I2C, 1-PWM, 1-UART port and also GPIO pins same as the Raspberry Pi.

The Grove Base Kit includes:

  • Base Hat for Raspberry Pi
    • Support Raspberry ⅔B/3B+/Zero
    • Built-in MicroController Unit (MCU)
    • 12-bit Analog to Digital Converter (ADC)
    • Multitype Grove port
  • Red LED button
    • Long operating life
    • Grove Digital interface
  • Temperature and humidity sensor (DHT11)
    • Relative humidity and temperature measurement
    • Full-range temperature compensation calibrated
    • Digital signal
    • Long-term stability
    • Long transmission distance
    • Low power consumption
  • 16 x 2 LCD (white on blue)
    • Super-twisted nematic (STN) display mode
    • Onboard MCU
    • I2C-bus interface
    • Supports English and Japanese fonts
  • Ultrasonic ranger
    • Detecting range: 3cm-350cm, best in 30° angle.
    • Grove interface
    • 5V DC power supply
    • Arduino library ready
  • Relay
  • Light sensor
  • Mini passive infrared motion motion sensor
  • Buzzer
  • Moisture sensor
  • Servo

OpenStore

About Luca Ruggeri

Leave a Reply

Your email address will not be published. Required fields are marked *