Romeo BLE: the Arduino Control Board for your Robot

By on July 1, 2017
Pin It

Romeo family is an All-in-One Arduino based control board especially designed for robotics applications from DFRobot.  It benefits from the Arduino open source platform and it is supported by thousands of open source codes.

The Romeo BLE has integrated bluetooth 4.0,  it is the first time to give a robot control board the power of easy set up.  Thanks to the bluetooth 4.0,  the Romeo BLE supports uploading sketch wireless which means you do not need to plug a cable to upload new code: just need a USB Bluno Link adapter.

The integrated 2 way DC motor driver and wireless socket allows you to start your own robot project immediately without the need for an additional motor driver.  Not just has the motor driver, Romeo is also designed to have extra power for servos which need more current.

Romeo is also featured with DFRobot’s standard 3Pin-out designed and compatible with Gravity series sensors and actuators.

Romeo BLE specifications:

  • Microcontroller: ATmega328P
  • Bootloader: Arduino UNO
  • On-board BLE chip: TI CC2540
  • Transmission range: 70m in free space
  • Support bluetooth remote update the Arduino program
  • Support Bluetooth HID
  • Support iBeacons
  • Support AT command to config the BLE
  • Support Transparent communication through Serial
  • Support the master-salve machine switch
  • Support usb update BLE chip program
  • 14 Digital I/O ports
  • 6 PWM Outputs (Pin11, Pin10, Pin9, Pin6, Pin5, Pin3)
  • 8 10-bit analog input ports
  • 3 I2Cs
  • Two way H-bridged Motor Driver with 2A maximum current
  • 5 Buttons
  • Support Male and Female Pin Header
  • Integrated sockets for APC220 RF Module
  • Power Supply Port: USB or DC2.1
  • External Power Supply Range: 5-23V
  • DC output: 5V/3.3V
  • Auto sensing/switching external power input
  • Size: 94mm x 80mm(3.70″x3.15″)

About Luca Ruggeri

One Comment

  1. Pingback: .NET i jiné ... : Odkazy z prohlížeče – 3.8.2017

Leave a Reply

Your email address will not be published. Required fields are marked *