Shield Xbee (Xbee module not included)

By on September 19, 2019
Pin It

The Xbee Shield allows an Arduino board to communicate wirelessly using Zigbee. It can be used as a serial / USB substitute or you can put it in command mode and configure it to adapt it to a wide variety of transmission networks. It also has male / female connectors to use the digital pins from 2 to 7 and the analog inputs, which are covered by the shield (pins 8 to 13 are not obstructed by the shield; therefore it is possible to use the

Go to Open-Electronics Store

About Boris Landoni

Boris Landoni is the technical manager of Open-Electronics.org. Skilled in the GSM field, embraces the Open Source philosophy and its projects are available to the community.

Leave a Reply

Your email address will not be published. Required fields are marked *