- How to Adjust X and Y Axis Scale in Arduino Serial Plotter (No Extra Software Needed)Posted 2 months ago
- Elettronici Entusiasti: Inspiring Makers at Maker Faire Rome 2024Posted 2 months ago
- makeITcircular 2024 content launched – Part of Maker Faire Rome 2024Posted 5 months ago
- Application For Maker Faire Rome 2024: Deadline June 20thPosted 6 months ago
- Building a 3D Digital Clock with ArduinoPosted 11 months ago
- Creating a controller for Minecraft with realistic body movements using ArduinoPosted 12 months ago
- Snowflake with ArduinoPosted 12 months ago
- Holographic Christmas TreePosted 1 year ago
- Segstick: Build Your Own Self-Balancing Vehicle in Just 2 Days with ArduinoPosted 1 year ago
- ZSWatch: An Open-Source Smartwatch Project Based on the Zephyr Operating SystemPosted 1 year ago
Project mangOH, open source reference design for the CF3 form factor modules
Project mangOH™ is an open source reference design for the CF3 form factor modules, including Sierra Wireless WP Series & HL Series. When used with WP Series, it provides an out-of-the box wireless and cloud connected reference design, and enables rapid prototyping of new ideas for IoT developers. With its Arduino connector and its 3 IoT connectors fully supported by the Legato™ platform, you can try out multiple wireless and sensor technology combinations to best meet your specific use-case requirements. Once your prototype is complete, you can then reuse the industrial-grade design and IoT modules in final production.
- Size: 100mm x 120mm (4in x 4.75in)
- 3 IoT Connectors
- 2 CF3 connectors
- 1 Arduino Leonardo connector
- 1 USB 2.0 OTG
- 1 USB 2.0 Host
- 1 RS232/Serial
- 1 RJ45/Ethernet
- Audio Jack
- SD card
- 3 SMA/uFL antenna connectors (Primary, Secondary/Diversity, GPS)
- Accelerometer, Gyroscope
- Battery/Battery Charging Management
LICENSE
Project mangOH by Sierra Wireless is licensed under a Creative Commons Attribution 4.0 International License.
Based on a work at source.sierrawireless.com/mangOH.
3D PRINTING
Project mangOH design is meant to fit in a Euro card standard size casing (100x120mm). Face plates can be 3D printed easily depending on the IoT Connectors you are using:
All 3D printable files can be found on: http://www.thingiverse.com/Sierra_Wireless_MangOH/designs
More info on the official homepage Project mangOH
Pingback: Project mangOH, open source reference design for the CF3 form factor modules