James Bruton’s 3D-printed, Arduino-powered Nerf blaster fires 10 darts at once

By on December 13, 2019
Pin It

 

Nerf guns can be a lot of fun, but what if you want your launcher to shoot 10 projectiles simultaneously? Is so, then look no further than James Bruton’s custom blaster.

His 3D-printed project employs two BLDC-powered rollers to accelerate cartridges of 10 darts each, and allows for quick reloading via a clever manual locking mechanism. The device holds five magazines, for total of 50 darts.

When loaded, an arcade-style button fires the darts, pushing them into the rollers at the same time using a couple of servo motors. Everything is powered by a six-cell 24V LiPo battery, while an Arduino Mega is used for control, and to track which cartridge is in place, enabling the operator to concentrate on getting shots downrange!

 

 

More info

About Emanuele Signoretta

Studying electronics and communication engineering at Politecnico di Torino. Electronics, IT and Open Source enthusiast.

Leave a Reply

Your email address will not be published. Required fields are marked *