- Terminus FE1.1 USB hub board: the solution to connect four USB devicesPosted 2 weeks ago
- Understanding the Mechanics of 3D PrintingPosted 2 months ago
- SDS011 the Air Quality SensorPosted 3 months ago
- NIXIE STYLE LED DISPLAYPosted 6 months ago
- TOTEM: learning by experimentingPosted 6 months ago
- Google Assistant Voice Controlled Switch – NodeMCU IOT ProjePosted 7 months ago
- Water Softener Salt Level MonitorPosted 7 months ago
- Sparkly Air SensorPosted 7 months ago
- Ultra sonic distance finder with live statusPosted 7 months ago
- Windows interface to have total control over lampsPosted 7 months ago
131 projects with Arduino & Genuino MKR1000
Arduino/Genuino MKR1000 has been designed to offers a practical and cost effective solution for makers seeking to add Wi-Fi connectivity to their projects with minimal previous experience in networking.
The board is so young but 131 projects have been already uploaded to Hackster.io. Here at the following link you can see the gallery: Arduino MKR1000 & Genuino MKR1000 projects.
Projects like a domotic greenhouse, a physical visualizer for your stats, a rfid door lock, and many interesting others.
Arduino MKR1000 has been designed to offer a practical and cost effective solution for makers seeking to add Wi-Fi connectivity to their projects with minimal previous experience in networking.
It is based on the Atmel ATSAMW25 SoC (System on Chip), that is part of the SmartConnect family of Atmel Wireless devices, specifically designed for IoT projects and devices.
The ATSAMW25 is composed of three main blocks:
• SAMD21 Cortex-M0+ 32bit low power ARM MCU
• WINC1500 low power 2.4GHz IEEE® 802.11 b/g/n Wi-Fi
• ECC508 CryptoAuthentication
The ATSAMW25 includes also a single 1×1 stream PCB Antenna.The design includes a Li-Po charging circuit that allows the Arduino/Genuino MKR1000 to run on battery power or external 5V, charging the Li-Po battery while running on external power. Switching from one source to the other is done automatically.
A good 32 bit computational power similar to the Zero board, the usual rich set of I/O interfaces, low power Wi-Fi with a Cryptochip for secure communication, and the ease of use of the Arduino Software (IDE) for code development and programming. All these features make this board the preferred choice for the emerging IoT battery-powered projects in a compact form factor.
The USB port can be used to supply power (5V) to the board.
The Arduino/Genuino MKR1000 is able to run with or without the Li-Po battery connected and has limited power consumption.The MKR1000 Wifi module supports certificate SHA 256. The 348 is still not yet supported.Warning: Unlike most Arduino & Genuino boards, the MKR1000 runs at 3.3V. The maximum voltage that the I/O pins can tolerate is 3.3V. Applying voltages higher than 3.3V to any I/O pin could damage the board. While output to 5V digital devices is possible, bidirectional communication with 5V devices needs proper level shifting.