Pop a wheelie with your electric skateboard, the hacker way

• Tweet
• Pin It

Using a bit of tech to make up for a lack of skill is a time-honoured tradition, otherwise known as cheating among those who acquired the skill the hard way. Learning to wheelie manual a skateboard is usually paid for in bruises, but [blezalex] got around that by letting his electric skateboard handle the balancing act.

At first glance the board looks and rides like an average DIY electric skateboard, with an off-the-shelf  a dual hub motor truck, VESC speed controllers and a wireless throttle. The party trick appears when the front wheel is popped off the ground, which activates the secret self-balancing mode. At this point a STM32F401 dev board and MPU-6050 IMU take over control of the motors, which is in turn controlled by leaning forward or backwards, like a hoverboard. The remote throttle turns into a dead man switch, which cuts power to the motors when released.

[blezalex] says he has had less that an hour of skateboard time in his life before getting on this one, which is a good testament of just how well it works. The biggest challenge was in getting the board to turn while on two wheels, which was solved by sensing side-to-side tilt of the board with the IMU and applying proportional differential torque to the wheels. With a bit of practice it’s also possible to smoothly shift between riding modes while moving.

We think this is a really elegant cheat, now we need to build one of our own. Fortunately the STM32 firmware and instructions are all up on GitHub. Building your own electric skateboard has become really simple with the availability of off-the-shelf components. We’ve also seen a bicycle with a wheelie cheat device to prevent you falling on your back

More info

Related Posts

• 

  Learn How to Design and Control a Robotic Arm with Arduino and Fusion 360
  Learn How to Design and Control a Robotic Arm with Arduino and Fusion 360
• 

  Terminus FE1.1 USB hub board: the solution to connect four USB devices
  Terminus FE1.1 USB hub board: the solution to connect four USB devices
• Understanding the Mechanics of 3D Printing
  Understanding the Mechanics of 3D Printing
• 

  SDS011 the Air Quality Sensor
  SDS011 the Air Quality Sensor