makerfairerome
Home   >   News   >   How I Made My Heating Smart Without Damaging Or Replacing Anything

How I Made My Heating Smart Without Damaging Or Replacing Anything

By on March 28, 2020
Pin It

 

Andy Bradford has been wanting to upgrade their heating system for a some time – but their house is rented. Damaging the house would cause them to lose their security deposit, “so the whole system must do no damage, be made only of removable parts and be installed without modifying any of the existing infrastructure.”

How did they do it?

“I used Tinkercad to design a driver head that would fit over the motor shaft and engage with the slot on the control spindle…I designed and printed a bracket that would hold the motor in place….”

The system is controlled via an Adafruit Feather ESP8266, connected to Adafruit IO

More info

OpenStore

About Emanuele Signoretta

Studying electronics and communication engineering at Politecnico di Torino. Electronics, IT and Open Source enthusiast.

Leave a Reply

Your email address will not be published. Required fields are marked *