GSM localizer without GPS – Part 6
Assembly

By on December 14, 2010
Pin It

Our localizer is definitely simple, yet it must be built with care, as all of its components are SMD. Once the two-sided board is ready, be sure you have a very fine-pointed welder of up to 20 watts and a 0.02-inch-diametered (possibly, even smaller) welding thread. First of all, take care of the microcontroller; solder a couple of stems opposite one another in order to stabilize it and then solder the rest of the stems. Then go on to the passive components, quartz and transistor. For the GSM/GPRS module, there is a small high-density connector to be soldered on the printed board, possibly with the aid of a magnifying lens to make sure there are no solder “whiskers” short-circuiting neighboring areas . On the mini-module just inserted you can attach and connect the SIM-card holder. Cellular antenna connection involves a triple golden spring contact which, pushing the component all the way into its connector, touches a pad purposely created in one of the corners of the c.s.; there one can solder the antenna cable or, depending on its shape, the antenna itself. For our model, we simply used a thread fragment about 3.15 inches long as an antenna; however, depending on the space available, one can choose a cellular antenna, even a printed-board one. Once everything has been assembled, one can proceed to the in-circuit programming of the microcontroller through the CN1 connector (8 poles). An additional two-pole miniature connector must be mounted for battery connection.

basette

pcb_board

PARTS LIST
R1, R5: 4,7 kohm (0805)
R2: 10 kohm (0805)
R3, R4: 330 ohm (0805)
C1: 100 µF 6,3 VL tantalum (CASE-B)
C2, C3: 100 nF multilayer (0805)
C4, C5: 10 pF ceramic (0805)
C6, C7: 470 µF 6,3 VL tantalum (CASE-X)
U1: PIC18LF6722 (MF833)
LD1: red LED
LD2: green LED
Q1: 20 MHz quartz (12SMX)
T1: BC817
SW1: Slide switch
GSM1: GSM0308
P1: Microswitch 90° SMD
Miscellaneous:
– CS connector 100 pin  for GSM
– 8 pole connector 90° 1 mm
– PCB

Download PCB details (Layout and Gerber):   PCB

About Staff

Leave a Reply

Your email address will not be published. Required fields are marked *